Skip to main content

Plumbing Maintenance Tips

 It is easy to ignore your home's plumbing system unless something goes wrong. Many homeowners, however, don't know about the cost of ignoring maintenance issues or how much it can cost when a small problem becomes a big issue.

Homeowners today have more resources at their disposal than ever before and there are many preventative measures that can be taken to avoid costly plumbing problems in the future.

Following a few precautions can help you avoid expensive repairs and keep your home's plumbing system running smoothly.

·          Don't allow grease to go down the drain, instead wipe it out with a paper towel or other absorbent material and dispose of it properly. Do not dispose of grease in the toilet.

·          Keep food scraps out of your pipes, especially grease or other fatty foods. Only pour water down the sink after very hot, soapy water has cleared kitchen pipes for example.

·          Maintain clean traps underneath sinks and tubs. The trap is the U-shaped pipe under a sink. The purpose of the trap is to prevent sewer gases from entering your home through drains and sewers. Traps need to be clear of debris.

·          Drain standing water away from your house or other buildings on your property that could freeze in cold weather, causing damage to pipes. Use heat tracing if necessary under concrete slabs.

Visit a plumber in McAdenville, NC for plumbing needs.

·          Avoid putting items such as disposable wipes, cotton balls a and dental floss down the drain. If you have fat or grease in your kitchen sink be sure to wipe it out using a paper towel and immediately put it into a garbage can that is outside of your home.

·          In addition to your local hardware store, online retailers are available to provide you with all of the tools and products necessary for routine maintenance, including drain cleaners, sewer jetters, plumbing snakes and replacement parts.

·          If your home is equipped with copper or PEX piping, be sure that they are protected from corrosion by keeping them coated in a water repellent sealant.

·          Use a pump or vent stack to get rid of water from your basement, if you have one.

·          Check the condition of the insulation on pipes located in attics and crawl spaces. Do not insulate any hot piping. If they are near a heat source, use heat tracing.

·          When you are replacing any parts of your home's plumbing system that have been corroded or damaged, use PVC rather than metal piping for water supply pipes if possible. This means fewer clogs and less rusting over time.

Labels:

Comments

Post a Comment

Popular posts from this blog

Appliance Installations That Require a Plumber

We all, at some point, need to purchase appliances. It is either when we move into a new house or need to replace our old existing appliances. Appliances like televisions, amplifiers, speakers, and many others do not require the help of a plumber. You can always install it on your own to the location you want it. You can mount it in walls or put them on tables. However, there are appliances that need a professional hand to have it installed properly and safely. These appliances include gas stoves and gas lines, dishwashers, ice makers, and gas dryers. They may look simple, but one wrong move can create damage to your property and to the appliance itself, and the worst is an accident that may occur. Gas Stoves and Gas Lines If you want to have a gas stove but you don't have a gas line, it is time to contact a reputable professional like the plumber in Prairie Village, KS . They can route a gas line for your gas stove safely. It is important to keep in mind the quality of the...
Post a Comment
Read more

DIY Vs Calling a Plumber for Water Heater Repair and Installation

 Many people do not understand the value of having a reliable water heater repair kit. In fact, many people are surprised to learn that the average homeowner spends up to an hour and a half on average just dealing with the plumbing issues of their home. In addition, how much does water heater repair cost? Typical residential water heater repair generally costs between $125 and $350, while commercial water heater repair costs anywhere from $500 to $800. Most homeowners initially pay around $270 for a basic water heater repair which consists of changing out the filter, checking the pressure, and running a test on the unit. The first thing you will likely hear is a rumbling noise. This noise is called the water tank tumbling noise and it is a sign of serious damage to the plumbing. If this noise continues, you should have your water heater system replaced immediately. If the noise is only intermittent, you may want to have the water heater repaired and replaced right away. You should ...
Post a Comment
Read more

Problems AC Preventative Maintenance Can Prevent

It is called preventative maintenance for a very important reason; it prevents any breakdowns from happening. Here are the things preventative maintenance can prevent: Electrical Issues With preventative maintenance, a technician will inspect all the electrical wirings and connections. It finds any loose connection and fixes it. It also fixes worn wires before it could cause power loss. Low Refrigerant Charge The substance responsible for removing the humidity and heat from your space is called refrigerant. Through the time, refrigerant could leak when there are holes and cracks on the line. It can lessen the cooling power of your system. As part of the maintenance, the lines are checked and the refrigerant charge is tested. If there is any problem, the technician can fix it right away. Dirty Coils There are two coils in AC, the evaporator coils and the condenser coils. The evaporator coils function to remove heat from the inside while the condenser coils release the hea...
Post a Comment
Read more